QSC EB3082 User Manual download pdf (Page 6)

Suspending the WideLine-8 Array

Rules for Suspension

•Correct use of all suspension hardware and components is imperative in sound system suspension and deployment.

•Always calculate suspended loads before lifting to ensure suspension components and hardware are used within their respective load limits.

•Research local codes and regulations to fully understand the requirements for suspended loads in the venue in which the equipment is to be

suspended.

•Use only shackle holes for suspension of array.

•Be absolutely certain of the integrity of any structural member intended to support suspended loads. Hidden structural members can have hid-

den structural weakness.

•Consult a Professional Mechanical or Structural Engineer licensed in the jurisdiction of the sound system installation to review, verify, and

approve all attachments to the building or structure.

•Never assume anything- Owner or third-party supplied suspension attachment points may not be adequate for the loads to be suspended.

•Employ the services of a Professional Rigger for hoisting, positioning, and attaching the equipment to the supporting structure.

•Always inspect all components (enclosures, suspension brackets, pins, frames, bolts, nuts, slings, shackles, etc.) for cracks, wear, deforma-

tion, corrosion, missing, loose, or damaged parts that could reduce the strength of the assembly before lifting. Discard any worn, defective, or

suspect parts and replace them with new appropriately load-rated parts.

Shock Loading

When a load is either moved or stopped, its static weight is magnified. Sudden movements can magnify the static weight several times. This

magnification of static weight is termed "shock loading". Shock loading poses a danger to equipment and workers. The effects of shock loading

can be instantaneous, or they may remain undetected unless the equipment is visually damaged. Avoiding shock loading requires careful plan-

ning and knowledge of equipment, suspension, and lifting practices.

Shock loading of equipment and structures is usually confined to lifting and installation, but natural forces (winds, earthquakes) can impose

shock loads several times the static load. This is why structures and suspension equipment must be capable of supporting several times the

weight of the equipment suspended.

WideLine-8 Working Load Limits and Design Factors

Table 1 lists the WideLine-8 suspension components and provides Working Load Limit data at various Design Factors. The tabulated Design Fac-

tors are for static loads only. The choice of which Design Factor to use will depend upon the jurisdiction and venue of installation, as well as the

conditions of suspension. Dynamic conditions are determined by unknown, installation-specific factors and should be referred to a Licensed

Structural Engineer for clarification before proceeding with any suspension of the equipment. The data presented is based upon the listed compo-

nent weights:

Figure 9: AF8-10 WideLine-8 to WideLine Adapter Frame

1- WideLine attachment knuckles

2- Knuckle retaining bolt

3- Rear link receiver for WideLine loudspeaker

4- WideLine-8 attachment links

5- Suspension plate attachment holes

Introduction (continued)

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

No comments

QSC EB3082 User Manual Page 6